Metal Band Heaters

Metal Band Heaters

Pointers for Choosing the Right Metal Band Heater

Metal band heaters are used to warm the contents of a drum or pail so it can be poured. These heaters contain electrical heating elements inside a metal sheath. Before you use a metal band heater, you need to know what type of drum or pail the contents are in and what temperature the contents can tolerate.

[<< BACK ]  


EXPO Electric Drum Heater - Thermostat Control - For 30 Gallon Steel Drums

EXPO Electric Drum Heater - Thermostat Control - For 30 Gallon Steel Drums


Product Code: TRX30L115

Price: $267.00


Qty 
Total actual cost of shipping this order to your location will be applied to your credit card

EXPO™ Electric Drum Heaters, with thermostat control and three-heat switch, are designed for use on 30 gallon all metal drums containing materials with good heat receptivity.

This unit has a thermostat range of 60° – 250° F and standard 120V rating.

The thermostat control is numbered 1-7.  The three-heat switch allows for three wattage ranges per thermostat setting -  the high setting is the for maximum watts (1920), the medium setting is for half the wattage (960) and the low is for 480 watts.

Electric drum heater installs easily with a spring-loaded toggle clamp for a snug fit around the steel drum.  This heater has a NEMA 5-20P Plug. This heater is for indoor use only.

The heater is equipped with neon pilot lights. The green pilot light will glow as long as the heater is plugged in. The red pilot light will glow until the heater reaches the set temperature and will go on and off as the thermostat cycles.

  • UL Listed
  • CSA Certified
  • One year warranty
  • 16.0
    30 gallon
    5-20 P
    Output 1920W @ 120V
    60 - 250
    120 VAC Single Phase
    1920-960-480
    12 lb
    18 1/2"
    5 3/8"
    5 3/8"

For use with steel drums and drums that do not contain a removable plastic liner.

Not for use with flammables or combustible materials or in a hazardous area.

Caution: Allowing liquid in a container to fall below the level of the heater will render the heater ineffective and could irreparably damage the baked on epoxy phenolic lining in lined steel drums.