Morse Drum Lifter


[<< BACK ]  


MORSE Hydra-Lift Karrier - Manual Tilt - Hydraulic Lift

MORSE Hydra-Lift Karrier - Manual Tilt - Hydraulic Lift


Product Code: 400A60

Price: $1,960.00


Qty 
Total actual cost of shipping this order to your location will be applied to your credit card

This MORSE Hydra-Lift Karrier has Hydraulic Lift and Manual Tilt. It allows one person to easily handle a fully loaded drum, up to 800 lb or half-full drums up to 500 lb. A half full drum will be unbalanced and bottom heavy so when you tilt it, the load shifts differently than if it were a full drum.

The MORCinch feature is designed to automatically adjust for 22 inch to 23 1/2 inch diameter steel or plastic drums. The manual tilting gear-drive has a hand crank to control the degree of tilt. It allows the drum to be rotated 360° either direction, holding the drum at any angle desired.

All welded steel frame rolls easily on two 8 inch polyolefin wheels and two 4 inch swivel casters, which are hidden under the base. It can be screwed into the plant floor if necessary. The hand-operated hydraulic pump gives full lift in about 45 strokes, which lifts the drum up to 60 inches.

Options Available include: Drum adapters for handling smaller drums, Bracket (Product code 4556-P) or Rim Clamp (Product code 4560-P) for handling plastic drums, and the MORStop Tilt-Brake which automatically stops and holds the tilt angle of the drum.

Spark-resistant models are available through special order.

  • Load, move, lift, tilt and drain full drums
  • Safe, one-person operation
  • Spark resistant models and various options are available through special order
  • 55"
    60"
    44"
    72"
    Hand Crank
    301 lb